Source guide
Haier Washer error-code sources
This page shows how the current Haier washer records are sourced, when they were verified, and where users can inspect the original manufacturer guidance.
Records covered4
Source URLs1
Source typeofficial
Last verified2026-07-30
Market scopeUnited States
Covered records
Haier Washer E0: Manufacturer guidance usually ties dO, E0, or E2 to an open-lid detection condition.Haier Washer E1: Manufacturer guidance usually ties E1 or E6 to a portable-washer drain issue.Haier Washer E3: Manufacturer guidance usually ties E3 to a portable-washer spin issue involving load size or level.Haier Washer E4: Manufacturer guidance usually ties E4 to a portable-washer fill issue involving supply or pressure.
Source hosts
- haierappliances.com
Source links are kept visible on each record page. FaultCodeLab uses short summaries and does not copy manuals or support pages verbatim.
Source review log
2026-07-30 - verifiedVerified the dO, E0, and E2 grouping and the proper-lid-closure check against Haier's portable-washer code table.2026-07-30 - verifiedVerified the E1/E6 grouping and the filter, standpipe, and visible drain-hose checks against Haier's portable-washer code table.2026-07-30 - verifiedVerified the E3 spin meaning and the overfill and four-leg level checks against Haier's portable-washer code table.2026-07-30 - verifiedVerified the E4 fill meaning and the water-on and pressure checks against Haier's portable-washer code table.
Coverage gaps
- Exact model-family pages remain gated until an official or manual-backed source supports the model-specific wording.
- Parts and service handoffs are not shown as recommendations until the source context is strong enough.
How this guide should be used
- Use the source links to verify the original manufacturer context.
- Check model notes before treating a display code as universal.
- Prefer safe first checks before any disassembly or parts decision.
Current limitations
- Manufacturer guidance can differ by model family and region.
- Alias/display variants are only added when the source supports them.
- Manual-backed model detail is planned but not bulk-generated.