What to check first
Stop normal operation while this warning is active. Follow only the documented safe checks or protective-drain instructions for the exact model.
Basic checks
- Record F01 and which controls still respond before switching the washer off; that observation helps service distinguish partial from complete control loss.
- From a dry position, look for water, unusual heat, a burning smell, smoke, or visible cord damage without opening the cabinet; any of these signs means the washer must remain off.
- If the plug, outlet, and floor are dry and there is no heat or burning smell, unplug the washer for at least two minutes as Hotpoint directs.
- Reconnect it, wait 30 seconds, and try one monitored start only; if F01 or the control failure returns, switch it off again.
Applicability
Regional guidance · Hotpoint washing machines covered by the UK support guide · United Kingdom
This F01 meaning and reset sequence come from Hotpoint's UK washing-machine guide; confirm the exact model manual because controls and code availability can differ by model and market.
Reset or retry steps
- Hotpoint UK specifies a minimum two-minute unplugged period, followed by reconnection, a 30-second wait, and one start attempt.
- Do not repeat the power cycle if F01 returns; a cleared display does not prove that the electronic fault is resolved.
When to call a technician
- Book Hotpoint service if F01 remains after the documented power reset, returns on the monitored start, or any washer function stays unavailable.
- Keep power off and seek urgent qualified help if there is smoke, a burning smell, unusual heat, repeated breaker operation, or moisture near the plug or outlet.
Before approving a paid visit, check warranty status and reviewquestions to ask before repair.
Can I keep using it?
Do not keep using the appliance if the code points to voltage, wiring, control power, burning smell, smoke, or a possible miswired supply.
- Safe next step
- Use only safe owner-level power checks, then involve a qualified technician or electrician when the source points to wiring or supply voltage.
- Stop when
- Breakers trip, lights dim, the appliance smells hot, wiring may be miswired, or the warning returns after a safe reset.
Stop normal use when water is visible or a leak warning is active. Stay clear if water could reach wiring or controls.
- Safe next step
- Follow the code-specific shutdown or protective-drain instructions, turn off water when appropriate, and avoid repeated resets. Do not interrupt a documented protective-drain sequence just to clear the display.
- Stop when
- Water is near wiring, cabinetry is getting wet, the leak returns, or the source is not safely visible.
Safety boundaries
Safe first
- Match the exact brand, appliance type, and displayed code first.
- Use the model manual as the final authority for access steps.
Do not do this
- Do not continue normal cycles while this code is active; any protective-drain sequence must follow the exact model instructions.
- Do not bypass locks, float switches, leak sensors, or other safety systems.
Common causes include
- Electronic control board not responding
- Some or all selectable functions unavailable
- Persistent control fault after the documented power reset
FAQ
What does Hotpoint Washer code F01 usually mean?
An electronic circuit-board fault may disable some or all washer functions. Model context matters: The Hotpoint UK guide gives one controlled power-reset attempt for F01 and directs persistent cases to an engineer.
Can I keep using the washer with code F01?
Stop normal operation until the issue and safety warnings have been addressed. Follow only the documented safe checks or protective-drain instructions for your model. Do not open the control console, touch board connections, or perform live-voltage tests; F01 is an internal electronic service fault.
When should I call a technician for Hotpoint F01?
Book Hotpoint service if F01 remains after the documented power reset, returns on the monitored start, or any washer function stays unavailable. A qualified technician may check Electronic control board against the model's service information before treating any part as failed.