Source guide
Hotpoint Washer error-code sources
This page shows how the current Hotpoint washer records are sourced, when they were verified, and where users can inspect the original manufacturer guidance.
Records covered6
Source URLs1
Source typeofficial
Last verified2026-07-30
Market scopeUnited Kingdom
Covered records
Hotpoint Washer F01: An electronic circuit-board fault may disable some or all washer functions.Hotpoint Washer F02: A motor-circuit fault may cause intermittent or absent drum rotation.Hotpoint Washer F05: A blocked waste path or pump issue may leave water in the drum.Hotpoint Washer F11: A pump-circuit fault may leave water in the washer or prevent pumping.Hotpoint Washer F12: An electronic-control fault may prevent the washer from turning on.Hotpoint Washer F18: An internal data error may disrupt some or all display functions.
Source hosts
- hotpoint.co.uk
Source links are kept visible on each record page. FaultCodeLab uses short summaries and does not copy manuals or support pages verbatim.
Source review log
2026-07-30 - verifiedVerified the F01 electronic circuit-board wording, unavailable-functions symptom, two-minute disconnect, 30-second wait, and engineer boundary on the official Hotpoint UK washer page.2026-07-30 - verifiedVerified the F02 motor-circuit label, intermittent/no-drum-rotation symptom, and engineer-only outcome on the official Hotpoint UK washer page.2026-07-30 - verifiedVerified the F05 waste-pipe/pump description, standing-water and door symptoms, model-dependent filter check, visible waste-path checks, and service boundary on the official Hotpoint UK washer page.2026-07-30 - verifiedVerified the F11 pump-circuit label, water-remains/not-pumping symptom, absence of owner repair steps, and engineer referral on the official Hotpoint UK washer page.2026-07-30 - verifiedVerified the F12 electronic-control label, washer-not-turning-on symptom, no-owner-reset posture, and engineer referral on the official Hotpoint UK washer page.2026-07-30 - verifiedVerified the F18 internal-data label, partial/all function-loss symptom, two-minute disconnect, 30-second wait, and engineer boundary on the official Hotpoint UK washer page.
Coverage gaps
- Exact model-family pages remain gated until an official or manual-backed source supports the model-specific wording.
- Parts and service handoffs are not shown as recommendations until the source context is strong enough.
How this guide should be used
- Use the source links to verify the original manufacturer context.
- Check model notes before treating a display code as universal.
- Prefer safe first checks before any disassembly or parts decision.
Current limitations
- Manufacturer guidance can differ by model family and region.
- Alias/display variants are only added when the source supports them.
- Manual-backed model detail is planned but not bulk-generated.