What to check first
Can I keep using it?
Do not keep using the appliance while this warning is active.
Do not keep running the appliance when water is visible, a leak warning is active, or water could reach wiring or controls.
- Safe next step
- Stop the cycle if safe, turn off water when appropriate, protect the floor, and avoid repeated resets until the leak source is understood.
- Stop when
- Water is near wiring, cabinetry is getting wet, the leak returns, or the source is not safely visible.
Do not keep using the appliance if the code points to voltage, wiring, control power, burning smell, smoke, or a possible miswired supply.
- Safe next step
- Use only safe owner-level power checks, then involve a qualified technician or electrician when the source points to wiring or supply voltage.
- Stop when
- Breakers trip, lights dim, the appliance smells hot, wiring may be miswired, or the warning returns after a safe reset.
Safety boundaries
Safe first
- Match the exact brand, appliance type, and displayed code first.
- Use the model manual as the final authority for access steps.
- Stop and address visible water before retrying the appliance.
- Disconnect power before any service-access step.
Do not do this
- Do not keep running the appliance while this code is active.
- Do not disconnect inlet hoses until the water supply is off.
- Do not bypass locks, float switches, leak sensors, or other safety systems.
Common causes include
- One or both household water faucets are closed
- An exposed fill hose is kinked or twisted
- Household water flow is interrupted or unusually weak
- A fill screen, mixing valve, or fill-level condition requires service
Basic checks
- Record Er, FL and stop repeated fill attempts while checking the supply from a dry position.
- Confirm that the hot and cold washer faucets are open only when both are safely reachable without moving the appliance or touching wet surfaces.
- Inspect only the visible fill hoses for a kink, twist, damage, or moisture; do not unscrew either hose or pull the washer away from the wall.
- Compare flow at a nearby outlet and note any recent household supply interruption; weak flow elsewhere points away from an appliance-only condition.
Reset or retry steps
- After normal household flow is restored, both faucets are open, exposed hoses are unrestricted, and the floor and electrical area are dry, disconnect power from a dry position for at least 15 seconds.
- Reconnect and try one monitored fill; stop if Er, FL remains, returns, or water enters abnormally, because repeated fill attempts can increase leak risk.
When to call a technician
- Contact Speed Queen service if Er, FL returns with normal household flow, open faucets, and no visible hose restriction.
- Keep the washer off and arrange prompt qualified help if a hose is damaged, water leaks, or moisture approaches the cord, plug, or outlet.
Before approving a paid visit, check warranty status and reviewquestions to ask before repair.
FAQ
What does Speed Queen Washer code Er, FL usually mean?
Usually indicates that the washer did not reach its fill level after 30 minutes. Model context matters: The guide defines Er, FL by a 30-minute wash or rinse fill and lists faucets, exposed hose routing, and filter screens as branches.
Can I keep using the washer with code Er, FL?
Do not keep using the appliance until the visible issue has been checked and the relevant safety warnings have been addressed. Do not unscrew a fill hose or clean the faucet-end or mixing-valve screens named by the guide; released water can reach mains-powered parts.
When should I call a technician for Speed Queen Er, FL?
Contact Speed Queen service if Er, FL returns with normal household flow, open faucets, and no visible hose restriction. A qualified technician may check Fill hose, Fill-screen system, Water mixing valve, and Fill-level sensing system against the model's service information before treating any part as failed.